Eaton PowerXL DH1 Series - Table 56. Version Info - P13.2; Table 57. Application Info - P13.3

53
Chapter 5—Basic application
POWERXL DH1 SERIES ADJUSTABLE FREQUENCY DRIVES MN040041EN—August 2019 www.eaton.com
Table 55. Basic Setting — P13.1, continued
Code Parameter Min. Max. Unit Default ID Note
P13.1.20

Output Display Unit 45 2424 10 = kg/h
11 = m3/s
12 = m3/min
13 = m3/h
14 = m/s
15 = mbar
16 = bar
17 = Pa
18 = kPa
19 = mVS
20 = kW
21 = °C
22 = GPM
23 = gal/s
24 = gal/min
25 = gal/h
26 = lb/s
27 = lb/min
28 = lb/h
29 = CFM
30 = ft3/s
31 = ft3/min
32 = ft3/h
33 = ft/s
34 = in wg
35 = ft wg
36 = PSI
37 = lb/in2
38 = HP
39 = °F
40 = PA
41 = WC
42 = HG
43 = ft
44 = m
45 = Hz
46 = strokes/min
P13.1.21

Output Display Unit Min -60000.00 See Par ID 2425 Varies 0.00 2460
P13.1.22

Output Display Unit Max See Par ID 2460 60000.00 Varies Varies 2425
P13.1.23 Keypad Lock Password 0 9999 0 75
Table 56. Version Info – P13.2
Code Parameter Min. Max. Unit Default ID Note
P13.2.1 Keypad Software Version 640
P13.2.2 Motor Control Software Version 642
P13.2.3 Application Software Version 644
P13.2.4 Software Bundle Version 1714
P13.3.4 Power Unit Serial Number 1270
P13.3.5 Control Unit Serial Number 1276
Table 57. Application Info – P13.3
Code Parameter Min. Max. Unit Default ID Note
P13.3.1 Brake Chopper 646 See Par ID 2118
P13.3.2 Brake Resistor Status 647 See Par ID 2118
P13.3.3 Serial Number 648
P13.3.4 Power Unit Serial Number 1270
P13.3.5 Control Unit Serial Number 1276
otes:N

Parameter value can only be changed after the drive has stopped.

Parameter value will be set to be default when changing macros.