Eaton PowerXL DH1 Series - Drive Control; Table 81. Analog Output 2 - P3.4; Table 82. Basic Setting - P4.1

70 POWERXL DH1 SERIES ADJUSTABLE FREQUENCY DRIVES MN040041EN—August 2019 www.eaton.com
Chapter 6 — PID Application
Table 81. Analog Output 2 — P3.4
Code Parameter Min. Max. Unit Default ID Note
P3.4.1

AO2 Mode 0 228 See Par ID 222
P3.4.2

AO2 Function 4 229 See Par ID 146
P3.4.3

AO2 Minimum 1 232 See Par ID 149
P3.4.4

AO2 Filter Time 0.00 10.00 s 1.00 230
P3.4.5

AO2 Scale 10 1000 % 100 233
P3.4.6

AO2 Inversion 0 231 See Par ID 181
P3.4.7

AO2 Offset -100.00 100.00 % 0.00 234
Drive Control
Table 82. Basic Setting — P4.1
Code Parameter Min. Max. Unit Default ID Note
P4.1.1

Keypad Reference See Par ID 101 See Par ID 102 Hz 0.00 141
P4.1.2

Keypad Direction 0 116 0 = Forward
1 = Reverse
P4.1.3

Keypad Stop 1 114 0 = Enabled-Keypad Operation
1 = Always Enabled
P4.1.4

Hand Key Enable 0 1724 0 = Enabled
1 = Disabled
P4.1.5

Reverse Enable 1 1679 See Par ID 1346
P4.1.6 Change PhaseSequence
Motor
0 2515 0 = Change Disable
1 = Change Enable
P4.1.7

Power Up HOA Select 0 1685 0 = Hold Last
1 = Hand Control
2 = Auto control
3 = Off
P4.1.9

Run Delay Time 0 32500 s 0 2423
P4.1.10

Start Mode 0 252 0 = Ramp
1 = Flying Start
P4.1.11

Stop Mode 0 253 0 = Coasting
1 = Ramp
P4.1.12

Ramp 1 Shape 0.0 10.0 s 0.0 247
P4.1.13

Ramp 2 Shape 0.0 10.0 s 0.0 248
P4.1.14

Accel Time 2 0.1 3000.0 s 10.0 249
P4.1.15

Decel Time 2 0.1 3000.0 s 10.0 250
P4.1.16

Power Loss Function 0 267 See Par ID 1346
P4.1.17

Power Loss Time 0.3 5.0 s 2.0 268
P4.1.18

2nd Stage Ramp Frequency See Par ID 101 See Par ID 102 Hz 30.00 2444
P4.1.19 Run Remove Stop Mode 2667
ote:N

Parameter value can only be changed after the drive has stopped.

Parameter value will be set to be default when changing macros.

Input function is Level sensed.