Eaton XV300 - Safety Regulations; General Safety Basics

2. Safety regulations
2.1 Basics
2. Safety regulations
2.1 Basics
The device has been designed according to the state of the art and all generally accep-
ted safety rules and standards. However, this alone cannot eliminate all potential haz-
ards, which is why it is necessary for you to be aware of all hazards and residual risks.
Do not run the device unless it is in perfect technical condition. Make sure to always
operate it as specified in this document and for the intended purpose.
Follow the safety instructions for the XV300!
The section on safety instructions must be read and understood by
everyone who will be working with the HMI panel before the actual
work is performed.
NOTICE
Pay attention to the hazard severity levels used throughout this doc-
umentation whenever a hazard is indicated. The hazard symbol and sig-
nal word used and the corresponding text will provide information
regarding the specific hazard and how to avoid or prevent it.
2.2 Mandatory requirements, personnel requirements
2.2.1 Occupational safety
All generally accepted occupational health and safety rules and standards (internal and
national) must be complied with, as must be all applicable laws and regulations in the
relevant country.
2.2.2 Personnel qualifications
The personnel responsible for installation, operation, maintenance, and repairs must
have the necessary qualifications for the work they will be performing. They must be
appropriately trained and/or briefed and be informed of all hazards and risks associated
with the device.
2.2.3 Device documentation
This manual is considered an integral part of the XV300 and must always be readily
available in the device's close proximity so that users have access to it.
XV30004/19 MN048017ENwww.eaton.eu
27