Eaton XV300 - Rear (Panel) Mounting XV-313

3. Installation
3.3 Mounting
3.3.3 Rear (panel) mounting Rear (panel) mounting XV-313
This mounting method is intended for use with sheet metal with a wall thickness of d =
1.5 mm (0.059") ± 0.1mm (0.004") (including any coatings on the sheet metal)
Version

A00
Standard version,
Sheet metal thickness of the mounting surround d = 1.5 mm (0.059") ± 0.1mm (0.004")
A11
Sheet metal thickness of the mounting surround d = 2 mm (0.08") ± 0.1mm (0.004")
Make the required mounting cutout.
Weld all the M4 x 12 weld studs onto the sheet as shown in the dimensional draw-
ing for mounting
Figure 21: M4 x 12 weld studs on sheet
Not a true-to-scale template! If necessary, make your own template based on the dimensional drawing
for mounting and the right scale.
199 ±0.5 mm (7.83 ±0.02")
182.7 ±0.1 mm (7.19 ±0.004")
156 ±0.5 mm (6.14 ±0.02")
126.8 ±0.1 mm (4.99 ±0.004")
141 ±0.5 mm (5.55 ±0.02")
R 3.5 ±0.1 mm
(R 0.14 ±0.004")
M4 x 12
Figure 22: Dimensional drawing for mounting XV-313-70-..
46
XV30004/19 MN048017ENwww.eaton.eu