Eaton XV300 - SmartWire-DT Coordinator; SmartWire-DT Powering

5. External connections
5.8 XV300 multi touch display as SmartWire-DT coordinator
5.8 XV300 multi touch display as SmartWire-DT coordinator
Applies only to XV300 SmartWire-DT units with a XV-3.3-..-.E.-...-.. connection.
In addition to the information in this document, you will also need the information in the
following documents in order to set up a SmartWire-DT network and install and operate
it using the SmartWire-DT master:
System description, engineering, installation, commissioning, and diagnostics for a
SWD network
SmartWire-DT The System Manual MN05006002Z
Setup, engineering, installation, etc. for the individual SWD modules
Manual for SmartWire-DT IP20 modules MN05006001Z
Manual for SmartWire-DT IP67 modules MN120006
5.8.1 SmartWire-DT powered via POW/AUX
The POW/AUX- interface is not electrically isolated.
CAUTION
NON-GALVANICALLY-ISOLATED INTERFACES
The XV300 may be damaged by potential differences.
The GND terminals of all bus modules must be connected.
Do not connect the connector to the XV300 or disconnect it without
first de-energizing the system.
Electrical connection
Power supply SmartWire-DT
POW/AUX
Figure 36: SmartWire-DT power connector
68
XV30004/19 MN048017ENwww.eaton.eu