Eaton XV300 - Interface Layout; Basic Interfaces; Optional Interfaces

5. External connections
5.1 Layout of interfaces
5.1 Layout of interfaces
Figure 28: Interfaces included on all HMI panels
 interface type
①
SD card slot
SDSC or SDHC conforming to the SDA 2.0 specification
②
USB Host USB 2.0, not galvanically isolated, plug type A, Full power (500 mA)
③
USB device USB 2.0, not galvanically isolated, plug type B
④
Ethernet 1 RJ-45 socket, 8-pole, 2 LEDs (CAT5e/6), LAN1, 10/100 Mbps
⑤
COM1 RS-232, not galvanically isolated, SUB-D plug 9-pole, UNC nuts for inter-
locking
⑥
COM2 RS-485, not galvanically isolated, SUB-D plug 9-pole, UNC nuts for inter-
locking
⑦
CAN CAN1, not galvanically isolated, SUB-D plug 9-pole, UNC nuts for inter-
locking
5.1.0.1 Optional Interfaces
Figure 29: XV300 multi touch display with all optional features
⑧
Ethernet 2 RJ-45 socket, 8-pole, 2 LEDs (CAT5e/6), LAN1, 10/100 Mbps
⑨
Profibus Profibus DP, not galvanically isolated, SUB-D socket 9-pole, UNC nuts for
interlocking
⑩
SmartWire-DT 4-pin WAGO connector (article no. 734-104) and 8-pole ribbon cable plug
XV30004/19 MN048017ENwww.eaton.eu
57