Eaton XV300 - External Connections; Connecting Peripheral Devices

5. External connections
5. External connections
With their interfaces, Eaton's XV300 multi touch displays make it possible to connect a
variety of peripheral devices and components.
DANGER
STRAY CURRENTS
Large equalizing currents between the functional earthing system and
the ground system of different devices may result in fire or in mal-
functions due to signal interference.
If necessary, route an equipotential bonding conductor, with a
cross-sectional area that is several times larger than that of the
cable shielding, parallel to the cable.
CAUTION
INTERFERENCES
The values specified in the technical data, as well as the device's elec-
tromagnetic compatibility (EMC), cannot be guaranteed if the following
are used: unsuitable cables, improperly assembled and terminated
cables, and/or wiring that does not conform to the applicable standards.
Only use cables assembled and terminated by professionals.
The cables being used must be assembled and terminated as required
by the port/interface description in this document.
When wiring the XV300 multi touch display, follow all instructions
regarding how to wire the corresponding port/interface.
All general Directives and standards must be complied with.
56
XV30004/19 MN048017ENwww.eaton.eu