Eaton XV300 - Ethernet Interfaces; Ethernet 1 and Ethernet 2

5. External connections
5.4 Ethernet 1, Ethernet 2
5.4 Ethernet 1, Ethernet 2
The Ethernet 1 port on the XV300 can be used as a communication interface or as a
real-time field bus interface.
The Ethernet 2 port on the XV300 multi touch display XV-3.3-..-C..-...-.. can only be used
as a communication interface without real-time requirements.
The Ethernet controllers support transfer rates of 10 Mbit/s and 100 Mbit/s.
When the green LEDlights up, this means that there is a LINK, i.e., that an active net-
work is connected and has been detected.
When the yellow LED flashes, this means that data is being transferred.

Figure 32: RJ-45 socket, 8-pole, 2 LEDs (CAT5e/6), LAN1, 10/100 Mbps
For the network, use shielded twisted-pair (STP) cables only.
For connecting:
The XV300 to a device:
l Use a crossover cable.
The XV300 to a hub/switch:
l Use a patch cable (1:1).
Max. cable length: 100m.
CAUTION
FORCES ON THE ETHERNET INTERFACE
Communications may be affected, and the connection's mechanical
components may be damaged, if the Ethernet interface is subjected to
strong vibrations or the RJ45 plug-in connection is subjected to pulling.
l Protect the RJ45 plug-in connection from strong vibrations.
l Protect the RJ45 plug-in connection from tensile forces at the
socket.
To commission the communication between the XV300 and the device, follow the
description for the connected device.
60
XV30004/19 MN048017ENwww.eaton.eu