EasyManua.ls Logo

Eaton XV300 - Approvals and Declarations

Eaton XV300
123 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix
A.1 Technical data
A.1.6 Approvals and declarations
The following specifications apply to all XV300 units.
Approvals and Declarations
cUL
UL 61010-2-201, UL File No. E205091
CE
XV300 units comply with all applicable European Union (EU) Directives and feature the
CE marking.
NEMA
XV300 devices comply with the applicable guidelines in North America
explosion safety
II 3D Ex tc IIIC T70°C IP6x:
zone 22, category 3D
l IP5x for group IIIB devices (nonconductive dust)
l IP6x for group IIIC devices (conductive dust)
For front mounting: fixing material that must be installed as specified without fail
-XV-303-70-..: on each 6 x Holding bracket with set screw
-XV-303-10-..: Ten (10) Holding bracket with set screw
-XV-303-15-..: Twelve (12) Holding bracket with set screw
For rear (wall) mounting: fastened as specified at all mounting points without fail.
-XV-313-70-..: on each 8 x
-XV-313-10-..: on each 10 x
Marine approval
(shipping clas-
sification)
Type approval for the XV300 7.0" and 10.1"provided that a radio interference sup-
pression filter for the device is installed in the wiring
DNVGL-CG-0039, from 11/2015
DNV GL Type Approval Certificate No: TAA00000NC
Applied Standards and Policies List
EMC (relevant for CE) 2004/108/EEC 2014/30/EU
IEC/EN 61000-6-2
Interference immunity for industrial environments
IEC/EN 61000-6-4
Emitted interference for industrial environments
Explosion protection (relevant for CE) ATEX directive 94/9/EG 2014/34/EG
IEC/EN 60079-0
Explosive atmospheres: Equipment - General require-
ments
IEC/EN 60079-31
Explosive atmospheres: Equipment dust ignition pro-
tection by enclosure t”
Security
IEC/EN 60950
Safety of Information Technology Equipment
UL 61010-2-201
Industrial Control Equipment
Section "Technical conditions for acceptance by
Underwriters Laboratories Inc. (UL)", page 39
DIN EN 60529
Degrees of protection provided by enclosures
NEMA 250-2003
Enclosures for electrical equipment (1000 Volts max-
imum)
Product standards
DIN EN 60898-1:2006-03
Electrical accessories - Circuit-breakers for overcurrent
protection for household and similar installations
EN 50178
Electronic equipment for use in power installations
IEC/EN 61131-2
Programmable logic controllers: Equipment require-
ments and tests
102
XV30004/19 MN048017ENwww.eaton.eu

Table of Contents

Related product manuals