Appendix 1：Installation & Setting Up
This appendix is to help you install and set up the printer. Normally this procedure will be carried out by
EC-JET Service Engineers when commissioning a new printer.
These notes are provided as a guide to be used if the printer is relocated or changes are made to
ancillary equipment. Guarding and safety interlocks should all be in place and working correctly. ECJET
can accept no liability for damage to either machine or personnel in the event of the printer being installed,
moved or maintained by unauthorized and/or untrained personnel.
If you are unsure of any procedure it is recommended that you contact your local EC-JET distributor.
Unpacking the System
1.1 Unpacking the System
Please carefully remove the cardboard packaging and check for the following contents:
● EC-JET printer
● EC-JET User Manual
● Final test print sample sheet
● Total Quality Plan packing card
● Key for cabinet
● A Guide to Quick Use
1.2 Where to Put the Printer
The EC-JET printer must be sited on a firm, solid base (preferably a EC-JET cabinet or mounting table)
and with a clean power supply, i.e. free from electrical interference.
The printer physical dimensions, in millimeters, are as follows:
360 (wide) x 404 (high) x 261 (deep).
The printer weighs 14 kg (not including ink or packaging).
1.3 Accessories
The following accessories are available for purchase with the EC-JET printer:
● RS232 Communications Cable - allows multiple, remote printer control from Windows based
PC system
● Shaft Encoder - enables even print width at uneven line speeds
● Photocell - detects presence of product
● Printhead Gantry
● Positive Air Kit - to prevent dust interfering with print quality
For a full list of all available accessories, please contact EC-JET or your EC-JET distributor.
To Next Page
Loading...