9.4.14 3.14 Over Speed (Variable Data)
This indicates that the printer has missed at least one pattern because it cannot generate the pattern’s
variable data (e.g. sequential numbers) at the required rate - i.e. the printer was still generating pixel data
for the next “print go” when the “print go” occurred.
The warning applies to the currently printing pattern - it is reset automatically when printing is restarted.
Possible cause
● The amount of variable data in the pattern is too long for the current rate of print triggers. Reduce the
amount of variable data, if possible.
NOTE: This warning indicates the printer cannot generate pixels fast enough, whereas System Warning
3.02 indicates the printer cannot print the raster fast enough.
This warning is only likely to occur for fast raster (e.g. raster smaller than 16 drops for Micro
print head), where pixel generation by the software is slower than the rate at which the
hardware can print raster.
9.4.15 3.15 Default Language
There is little chance of fault of default language.
Otherwise, contact your local EC-JET distributor.
9.4.16 3.16 Memory Failure
Possible cause
● The battery backup has failed (exhausted battery). Recharge the battery by switching the printer on for
24 hours. Otherwise, contact your local EC-JET distributor.
9.4.17 3.17 Memory Corrupt
The system will still function but some values may have been reset to their defaults.
Possible cause
● The battery backup has failed (exhausted battery). Recharge the battery by switching the printer on for
24 hours. Otherwise, contact your local EC-JET distributor.
9.4.18 3.18 No Message Stored In Memory
This warning is reported if there is no message stored in memory. Printing cannot be started if there is no
message stored.
Possible causes
● The user has cleared the message memory by selecting and has then failed to enter a new
message.
● The battery backup has failed:
Contact your local EC-JET distributor.
To Next Page
Loading...