●The next object has arrived at the print head before the last pattern is complete because:
1. The line speed is too fast.
2. The pattern is too long compared to the size of the objects to be printed on.
●The photocell is giving false triggers.
9.4.4 3.03 Ink Low
If the ink level sensor indicates that the ink reservoir is low then this warning is given. It is
cleared automatically when a sufficient amount of ink is added (500ml).
DO NOT put in more than one bottle. If the ink low condition is detected before the jet is
started, then the jet cannot be started until the ink tank is replenished.
If the condition is detected while the jet is running, the jet will continue to run for several hours until the ink
is dangerously low, at which point a failure will occur (see Print Failure “2.06”).
9.4.5 3.04 Solvent Low
If the solvent level sensor indicates that the solvent reservoir is low then, this warning is
given. It is cleared automatically when a sufficient amount of solvent is added to the
reservoir.
DO NOT put in more than one bottle (500ml). If the solvent low condition is detected
before the jet is started, then the jet cannot be started until the solvent tank is replenished.
If the condition is detected while the jet is running, the jet will continue to run regardless, but no attempt
will be made to add solvent.
9.4.6 3.05 Print Go / Remote Data
A “print go” has occurred and printing data has not been received from the remote interface.
Make sure the transmission cable and the port are right setting.
9.4.7 3.06 Service Time
When the jet is started, the time remaining to the next service is checked. If it exceeds 4000 hours then
this warning is reported and the jet is started as normal.
This warning will be reported on every jet start up until the service time has been reset.
Maintenance should be made when there is warning, otherwise it will affect the machine performance
and stability.
9.4.8 3.07 Print Head Cover Off
This warning is reported if the print head cover is removed.
The supply to the EHT plates is switched off (by hardware) when the cover is removed.
WARNING: THERE IS A LINK WHICH, WHEN FITTED, DISABLES THIS AUTOMATIC
SHUT OFF. THEREFORE, THE PRESENCE OF THIS WARNING IS NOT A
GUARANTEE THATTHE EHT IS OFF.
Printing is suspended when the cover is removed and is resumed a few seconds after the
cover is refitted.
The warning applies to the currently printing pattern - it is reset automatically when
To Next Page
Loading...