6.2
DryExx wall mounting
®
The applicator station DryExx
®
is shipped from the factory ready for connection. W
all
mounting is the intended installation mode, or alternatively onto a standard console. The
components should ideally be set up in the area of the filling plant. In this process, it
should be noted that the units are easily accessible and the max. permissible ambient
conditions are observed. In the event of installation on a stand console, ensure that this is
securely anchored to the floor.
The dimensions of the DryExx
®
are given here:
Ä
Chapter 14.4.1 „DryExxEco
®
“ on page 91
The following points should be noted during assembly:
– Make sure there is adequate access for maintenance to be carried out!
– The location must be as dry and frost-protected as possible.
– Install the applicator station as close as possible to where the lubricant is
stored (canister, barrel, container
, tank) to ensure that the suction tubing is
as short as possible.
– The DryExx
®
must be installed horizontally and securely.
The procedure should be selected as follows:
1. Choose a suitable mounting location (wall, etc.).
2. Ensure that all required supply lines (power, water
, signal cable to the control unit,
dosing medium) are present.
3. Measure the mounting points and transfer to the mounting site.
4. Make the holes.
5.
DryExx
®
should be mounted using the fastening elements provided.
6. Check the alignment, adjust if necessary.
7. Carry out connection work.
Assembly
DryExx wall mounting®
36Rev. 02-09.2017
To Next Page
Loading...
