Ecolab DryExxEco Advanced-ETH - System Settings [Setup] [Applicator Stations;Valves]

10.4.6.1 „System settings“ [Setup] [Applicator stations/valves]
Depending on how many lubrication circuits are used, the valves can be divided into two
zones (e.g. Filler 1 / Filler 2). The overview shows the activated valves [x].
NOTICE!
The valves are NEVER permitted to be used twice. I.e. only ever in zone 1 or
zone 2.
Fig. 24: „System settings“ [Setup] [Applicator stations/valves]
1. button [Setup] Press to access the [Setup] .
ð
The overview: „Setup: Selection“ is displayed.
2. Press button [Setup applicator stations/valves] .
ð
The overview: „Version selection“ is displayed.
3. Press button [Valve type]
.
ð
The operating mode of the valves can be set to "Differential pressure activation"
or "Direct activation" (Pos. A).
4. Press button [Valve Allocation] .
ð
The screen switches over to the „V
alve allocation: V1 - V16“ .
Layout of the software display
System settings > Overview: System settings Setup
63 Rev. 02-09.2017