Ecolab DryExxEco Advanced-ETH - General Parameters] - [Operating Mode] - [Monitoring Consumption]

10.8.2.1 [General parameters] - [operating mode] - [Monitoring consumption]
The monitoring of the dosing quantity of all dosing circuits is carried out here.
Fig. 42: Overview: [General parameters] - [operating mode] - [Monitoring consumption]
1 Valve number
2 Value of the actual dosing.
3 The button [=>] can be used to transfer the value to
„Set“ .
4 Display of the „Set“ value.
5 +/- tolerance of the set value in %.
6 +/- tolerance value conversion into absolute values
(ml).
Pressing the button displays a second button on the subsequent
screens. These buttons can be used display the (next) or the
(previous) screen with the corresponding valves.
1.
In the „home screen“
Ä Chapter 10.3 „„home screen“ (start screen)“ on page 54
use the
button to switch to the general parameters.
ð
The overview: „Parameters: General“ is displayed.
Ä Chapter 10.8.1 „[General parameters]“ on page 73
2. Press button [operating mode] .
ð
The overview: „Operating modes“ is displayed.
Ä Chapter 10.8.2 „Overview: [General parameters] -
[operating mode]“ on page 74
3. Press button [Monitor Consumption] .
ð
Monitoring the dosing quantity of all dosing circuits is displayed.
4.
Press the button.
ð
The next screen with the corresponding valves is displayed.
5.
Press the button.
ð
The previous screen with the corresponding valves is displayed.
Layout of the software display
Overview: General parameters > Overview: General parameters - operating mode
75 Rev. 02-09.2017