10.7 Overview: [Circuit Parameters]
The button on the start screen of the control
Ä
Chapter 10.3 „„home
screen“ (start screen)“ on page 54can be used to switch over to the „Circuit Parameters“ .
In [Circuit Parameters] the parameter setting of the lubricant circuits of the system are set.
Only sections (plants) to which valves have been allocated are displayed.
Fig. 35: Overview: [Circuit Parameters]
1.
In the „home screen“
Ä
Chapter 10.3 „„home screen“ (start screen)“ on page 54
use the
button to switch to the parameter selection.
ð
The screen switches to the display „Parameter: section selection“.
2. Press either [Section 1]
or
[Section 2] .
ð
The „Circuit Selection“ is displayed.
3. Press either [Circuit 1], [Circuit 2] or [Circuit 3] .
ð
The settings for the selected „section“ and „circuit“ are displayed.
4. Press the button [T
imes] .
ð
The settings for the „valve times“ and „pause times“ are displayed.
5. Press the button [Boost T
imes] .
ð
The setting for activating the „valve times“ is displayed.
Layout of the software display
Overview: Circuit Parameters
69 Rev. 02-09.2017
To Next Page
Loading...
