Ecolab DryExxEco Advanced-ETH - Circuit Parameters]; Circuit Parameters] - [Boost Times]; Circuit Parameters] - [Times]

10.7.1 [Circuit parameters]
The cycle times and pause times of a lubrication circuit and the enabling signal are
displayed here. The start of the booster can also be carried out here.
Fig. 36: [Circuit parameters] - „home screen“
1
2 Plant number (sector)
3 Cycle time (actual)
4 Pause time (actual)
5 Status of the booster
6 Current release status
7
8
9
10 Current booster status
11 Pause time (set)
12 Cycle time (set)
13 Sequential valve number on the system
14 Circuit number
10.7.2 [Circuit parameters] - [Times]
The cycle and pause times of a lubricant circuit are set here.
Fig. 37: [Circuit parameters] - [Times]
1
2 Plant number (sector)
3 Cycle time (set)
4 Pause time (set)
5
6 Sequential valve number
6 Circuit number
10.7.3 [Circuit parameters] - [Boost times]
The separate booster function can be activated here.
Fig. 38: [Circuit parameters] - [Boost times]
1
2 Plant number (sector)
3 Activation time: (Set and actual). Time for the active
booster function.
Layout of the software display
Overview: Circuit Parameters > Circuit parameters - Boost times
70Rev. 02-09.2017