Ecolab DryExxEco Advanced-ETH - Home Screen Navigation; System Settings Management

10.3 „home screen“ (start screen)
After connecting the power supply by switching on the main switch on the control cabinet
(see
Ä Chapter 9 „DryExxEco control
®
Advanced-ETH“ on page 49, Pos. 2), the display
will be the „home screen“. From this „home screen“ you can call up all the settings on the
control.
The home screen displays the following:
Fig. 13: Start screen
1 Status display / message: „No fault within the control“ .
2
The manufacturer logo
acts as a
button to switch over to the „System settings“ .
Ä Chapter 10.4 „ „System settings“ “ on page 54
3 Type of software control: „DryExx Eco Advanced-ETH“
4
Button to switch over to „Statistics ON/
OFF“ .
Ä Chapter 10.5 „[Statistics]“ on page 65
5
Button to switch over to the Archive
Ä Chapter 10.6 „Overview: [Archive]“ on page 65
6
Button to switch over to „Circuit
Parameters“ .
Ä Chapter 10.7 „Overview:
[Circuit Parameters]“ on page 69
7
Button to switch over to „Messages“ .
Ä Chapter 10.9 „[Messages]“ on page 76
8
Button to „logout“ from the system.
Ä Chapter 10.10 „Control: Logout“ on page 77
9
Button to switch over to „General
Parameters“ .
Ä Chapter 10.8 „Overview:
[General parameters]“ on page 72
10 Display of the valves integrated into the system.
11
Button to run the „LED test“ .
Ä Chapter 10.11 „LED Test“ on page 77
12 Current set date date and time
10.4 „System settings“
Access to the „System settings“ on the control is not immediately visible and is
hidden behind the manufacturer logo. Pressing the manufacturer logo
[ECOLAB] calls up the „System settings“ .
Fig. 14: System settings
1
switches back over to the „home screen“ .
Ä Chapter 10.3 „ „home screen“ (start
screen)“ on page 54
Layout of the software display
System settings
54Rev. 02-09.2017