What to do if my EDAN F9 LCD has no display, the power indicator is off, and the fan doesn’t run?
First, verify the power cord isn't damaged and is properly connected to both the monitor's power socket and the hospital AC outlet. If the issue persists, the fuses may be blown and need replacement. As a last resort, the main control board may be defective, requiring replacement.
Why won't my EDAN F9 Medical Equipment connect to a network?
There could be several reasons why your device isn't connecting to the network. The RS232 or Ethernet socket might be defective, requiring replacement. There may be a bad connection between the bottom interfaces board and the main control board, so check the connection. It's also possible that the device number overlaps with another device on the network, so try changing the device number. Finally, the server IP settings might be incorrect, so ensure they are set correctly. In some cases, the main control board may be defective and needs replacing.
What to do if my EDAN F9 abruptly switches off?
An abrupt shutdown can occur for several reasons. The monitor might have been struck by strong high voltage, such as a lightning strike, so check the power supply and earth system. Alternatively, there could be bad power supply performance, requiring a replacement power supply. A defective main control board or bad connection may also cause this problem; in these cases, replace the main control board or check all the connectors, respectively.
General| Brand | EDAN |
|---|---|
| Model | F9 |
| Category | Medical Equipment |
| Language | English |
To Next Page
