F9 Fetal & maternal Monitor Service Manual System Configuration
- 18 -
5.10 Configuring for Ethernet Connecting
When connecting the monitor to a PC via Ethernet, you need to set the server IP and Ethernet
port:
1 Open the System Setup menu.
2 Select Network Setup.
3 Select Server IP.
4 Set the IP address to be the same as that of the PC.
5 Select Ethernet Port.
6 Set the port number to be the same as that of the software.
7 Select OK in the Network Setup menu.
8 Select OK in the System Setup menu.
5.11 Changing Trace Width
In order to differentiate the traces clearly, you may assign different widths for different traces.
1 Open the System Setup menu.
2 Select Recorder Setup.
3 Select FHR1.
4 Select a number from 1, 2, 3 and 4. The width of the trace increases by degrees from 1 to
4.
5 Set width of FHR2, AFM and TOCO traces in the same way.
6 Select OK in the Recorder Setup menu.
7 Select OK in the System Setup menu.
5.12 Changing Paper Style
The paper style determines the range of FHR trace background pane bar. Observe the recorder
paper that the user has ordered, 30 ~ 240 is USA style; 50 ~ 210 is International style.
1 Open the System Setup menu.
2 Select Recorder Setup.
3 Select the pane next to Paper Style.
4 Select the required style from USA and International.
5 Select OK in the Recorder Setup menu.
6 Select OK in the System Setup menu.