F9 Fetal & maternal Monitor Service Manual System Configuration
- 15 -
5.4 Clearing Data
The monitor saves the most recent 24-hour data in its long-term memory automatically. In order
to delete this data,
1 Open the System Setup menu.
2 Select Clear Data.
3 Select OK.
NOTE:
The archives will not be cleared with the data. You may use the archive opening key to
delete the archives.
5.5 Checking Product Information
The product information menu lists the hardware and software information of this monitor. This
information can be very helpful when contacting the manufacturer for service.
To check the product information,
1 Open the System Setup menu.
2 Select Product Information.
5.6 Calibrating Touch Screen
NOTE:
Make sure the touch screen is enabled before trying to open the touch screen calibration
menu.
When the monitor does not react to each touch on the touch screen properly, calibrate the touch
screen by performing the following steps:
1 Open the System Setup menu.
2 Select Touch Screen Calibration.
3 Touch the cross mark “X” of button 1.
4 Touch the cross mark “X” of button 2.
5 Touch the EXIT button.
To Next Page
Loading...
Need help?
General
