F9 Fetal & maternal Monitor Service Manual Overview
- 6 -
WARNING
7 Accessory equipment connected to the analog and digital interfaces must be
certified according to the respective IEC/EN standards (e.g. IEC/EN 60950 for data
processing equipment and IEC/EN 60601-1 for medical equipment). Furthermore all
configurations shall comply with the valid version of the system standard IEC/EN
60601-1-1. Everybody who connects additional equipment to the signal input
connector or signal output connector configures a medical system, and is therefore
responsible that the system complies with the requirements of the valid version of
the system standard IEC/EN 60601-1-1. If in doubt, consult our technical service
department or your local distributor.
8 Do not unplug the battery in the course monitoring.
9 Do not connect battery directly to an electric outlet or cigarette lighter charger.
10 Do not solder the leading wire and the battery terminal directly.
CAUTION
1 Refer servicing to qualified personnel.
2 The device is designed for continuous operation and is “ordinary” (i.e. not drip or
splash-proof).
3 Do not operate the unit if it is damp or wet because of condensation or spills. Avoid
using the equipment immediately after moving it from a cold environment to a warm,
humid location
4 While the battery is charged, used or stored, keep it away from objects or materials
with static electric charges.
To Next Page
Loading...
Need help?
General
