Vital Signs Monitor Service Manual Installation
- 9 -
3.3 Safety Requirements
CAUTION
1 SHOCK HAZARD- the power receptacle must be a three-wire grounded outlet. A
hospital grade outlet is required. Never adapt the three-prong plug from the monitor
to fit a two-slot outlet.
2 Do not touch signal input or output connector and the patient simultaneously.
3 Devices connecting with monitor should be equipotential.
4 Do not switch on the monitor until all cables have been properly connected and
verified.
3.4 Installing the Monitor
To install the monitor on a flat surface
Place the monitor on a flat surface. Make sure the surface does not vibrate, and is free of
corrosive medicine and dust.
Figure 3-1 iM3 on a flat surface
To Next Page
Loading...
