INTRODUCTION 12
• When connecting or disconnecting the power cord:
– Only use the power cord that shipped with the E-42B or an appropriate replacement
power cord available from an authorized provider.
– Always disconnect the power cord from the E-42B connector panel before opening the
unit and servicing internal components.
– Do not pull on the power cord when unplugging the E-42B. Instead, pull the plug.
– Do not place objects on the power cord. Place the power cord away from foot traffic.
– Do not tamper with or disable the power cord grounding plug.
– Do not use a 3-prong adapter in a 2-hole, ungrounded outlet.
– Do not use an extension cord.
– Do not plug the E-42B into a circuit with heating or refrigeration equipment (including
water dispensers).
– Do not plug the E-42B into a switchable power outlet. This can result in the E-42B
being turned off accidentally.
• Never set any liquid on or near the E-42B or the copier/printer. If liquid is spilled into the
E-42B or the copier/printer, disconnect the power cord immediately.
• Do not attempt to open the power supply, DVD drive, or hard disk drive.
• Handle the E-42B LCD window with care.
If the E-42B LCD window breaks and the liquid crystal inside leaks out, avoid contact. If you
come in contact with the liquid crystal, immediately wash it off your skin with soap and
water.
• Use care when handling parts of the E-42B, as some edges on the unit may be sharp.
• Do not install third-party applications onto the E-42B. Third-party applications are not
supported and can cause system problems. Although virus scans are permitted on the E-42B,
antivirus software should not be loaded in memory-resident mode.
• Do not change the Windows operating system software preference settings.
Depending on the changes made, the E-42B may become unstable or even unusable. If this
occurs, we recommend that you reinstall the E-42B System Software, which reliably restores
the Windows operating system software to its factory defaults.
• Never alter an existing network without permission.
The E-42B will probably be connected to an existing Local Area Network (LAN) based on
Ethernet hardware. The network is the link between the customer’s computer, existing laser
printers, and other prepress equipment. Never disturb the LAN by breaking or making a
network connection, altering termination, installing or removing networking hardware or
software, or shutting down networked devices without the knowledge and explicit permission
of the system or network administrator or shop supervisor.
To Next Page
Loading...
