SYSTEM SOFTWARE INSTALLATION 89
Changing the factory default language
Before installing system software, you can change the E-42B default language preinstalled at
the factory using the Configure tool, available through Command WorkStation and
WebTools.
TO CHANGE THE FACTORY DEFAULT LANGUAGE
1 Open Configure through either Command WorkStation or WebTools.
2 Click Server > Regional Settings > Server Language, and choose a language.
3 Click Apply.
Changing languages takes three to five minutes.
Installing system software
E-42B system software is provided on the following media:
• System Software DVDs contain the Windows operating system software and
the Fiery Server software.
• User Software DVD contains the E-42B user software.
Install system software in the following cases:
• The hard disk drive or motherboard is replaced.
• The E-42B must be updated to a more recent version of the system software.
System software installation takes approximately 1 hour and 10 minutes (not including the
time required to configure Setup).
TO INSTALL SYSTEM SOFTWARE
Notify the network administrator at the customer site that some archived jobs may no longer
print after you install an updated version of system software.
1 Back up the E-42B configuration, if possible.
For more information, see Configuration and Setup, which is part of the user documentation
set.
2 If you have not done so already, allow the network administrator the opportunity to print the
Job Log and save any custom simulation and output profiles. Also, print the following (if
possible):
• Configuration page: Lists any installed options and records the customer’s current Setup
configuration.
•
Font List: Lists the fonts currently on the hard disk drive. Along with the fonts provided in
system software, the customer may have installed additional fonts.
To Next Page
Loading...
Need help?
General
