To Next Page

To Previous Page

INSTALLING HARDWARE 15

INSTALLING HARDWARE

Installation problems are easier to avoid and diagnose if you proceed from the component to

the system level and verify functionality at each stage. The following procedure should take

place:

•Preparing for hardware installation or service procedures (see page 15)

• Installation sequence (see page 15)

• Checking the customer site (see page 16)

• Unpacking the E-42B (see page 18)

• Installing the E-42B and connecting it to the copier/printer and the network (see page 19)

• Completing the installation (see page 23)

– Print a Test Page and a Configuration page.

– If the E-42B requires a static IP address (for example, in a non-DHCP network

environment), work with the network administrator to configure it

as described on page 22.

– Remind the site administrator to install the current user software on networked

computers that print to the E-42B (see Printing and Utilities, which are part of the user

documentation set.

Installation sequence

Because the E-42B is a node on the customer’s computer network, make sure that you

coordinate your scheduled installation with the network administrator at the customer site.

For Network Setup information, refer the network administrator to Configuration and Setup,

which is part of the user documentation set.

NOTE: You can change the default language that is preinstalled at the factory using the

Configure tool available through Command WorkStation and WebTools. Start Configure,

choose Server > General > Choose Server Language, and then click Apply. It takes up to three

minutes to change languages.

1 Check installation requirements and verify site conditions.

If possible, obtain verification that the network is operational (see page 16).

2 Unpack the E-42B (see page 18).

3 Connect the monitor, keyboard, mouse, and furniture to the E-42B if applicable.

For more information on setting up the fainter, see Furniture, 19-inch Monitor, Keyboard, and

Mouse for PRO Series.

4 Connect the interface cables (see page 20).

• Network cable (upper RJ-45)

EFI E-42B User Manual

Questions and Answers: