PREPARING THE COPIER/PRINTER TO CONNECT TO THE E-42B 124
4 Insert the Gigabit Ethernet controller board [D] ( x 1, x 2).
FIGURE 32: Attaching the controller board.
5 Reassemble all covers.
6 Connect the power cord of the copier/printer to a power outlet.
7 Turn the copier/printer main power switch on and enter SP mode.
8 Change the network setting of SP5895-002 from “0” to “1”.
9 Press the On switch (operation switch) on the copier/printer operation panel and wait until
the On indicator is off.
10 Turn the copier/printer main power switch off.
11 Connect the copier/printer to the E-42B (see page 20).
To Next Page
Loading...
