INSTALLING HARDWARE 23
Completing installation and starting up
To finish the installation of the E-42B at the customer site, make sure to do the following:
1 Make sure that the copier/printer is powered on.
2 Power on the E-42B (see page 32).
Make sure that the power cord is attached and that the power switch on the connector panel is
in the ON position. Press the power button on the front panel once and release the button.
The power supply automatically senses the correct voltage.
3 Wait for the system to power on and for the E-42B Info screen to reach Idle.
NOTE: If the message “Check power and cable” displays on the copier/printer copier control
panel, verify that the copier/printer interface cable is connected correctly to the copier/printer
and the E-42B.
4 Perform any required system software upgrades.
For instructions, see the documentation that accompanies the E-42B service upgrade.
Updates to Fiery Server Software may be available for the E-42B from a variety of sources (for
example, System Updates (see page 92), patches provided on CD, or patches downloaded by
the customer).
Windows operating system updates should be obtained from Microsoft directly. Because such
updates are available directly from Microsoft, EFI does not maintain or provide them via the
System Updates feature.
5 Print a Test Page and a Configuration page and ask the customer to verify the output.
6 If the E-42B requires a static IP address (for example, in a non-DHCP network environment),
work with the network administrator to configure it as described on page 22.
7 Change the factory default language, if needed.
For more information on changing the factory default language, see page 89.
8 Ask the network administrator to perform Setup and to print some test documents over
the network.
9 Store the output and the current Configuration page(s) near the copier/printer.
10 Inform the site administrator that the E-42B user software must be installed on networked
computers that print to the E-42B.
11 Ask the site administrator to make sure that all media (DVDs and/or CDs) shipped with the
E-42B is stored in a safe location, accessible to you.
To Next Page
Loading...
Need help?
General
