EFI E-42B - Page 90

SYSTEM SOFTWARE INSTALLATION 90
3 Remove all USB devices (except for the keyboard and mouse).
The system may hang if USB devices are connected to the E-42B during software installation.
4 Insert System Software 1 DVD into the DVD drive.
NOTE: If you installed a new hard disk drive, power on the system, insert the System Software
1 DVD, allow the system to boot from the System Software 1 DVD, and then proceed to the
next step.
5 From the control panel (or the Start menu, if a monitor is connected), restart the E-42B
(approximately three minutes).
Do not push any buttons while the system is rebooting.
6 When the Language Select screen displays, select a language.
7 When the “What do you want to do?” screen displays, choose New Installation.
8 When the “Erase hard disk?” message appears, choose Continue.
9 At the prompt, if you want to install the optional software “Adobe Acrobat/Enfocus PitStop”,
choose Install. If not, choose Skip.
10 At the prompt for each DVD, insert System Software 2 DVD, and then System Software 3 DVD,
for the OS installation.
11 At the prompt, insert the User Software DVD. After a brief pause, installation continues
(approximately 10 minutes).
During this segment, the following installations are performed:
• The entire contents of the User Software DVD are copied to a shared folder on the E-42B
hard disk drive, in e:\efi\user_sw.
• User software is installed on the E-42B.
After installation, when the E-42B is connected to the customer’s network, users can access
the user software in the shared folder and install it on client computers.
If the installation hangs during this segment, possibly the time and date were not configured
in the BIOS following removal of the motherboard battery. To troubleshoot, see page 115.
12 Remove the User Software DVD when it ejects automatically.
13 When the “Insert Adobe/ Acrobat/ Enfocus Pitstop” message displays, insert the Acrobat/
PitStop DVD.
Installing Adobe Acrobat/PitStop takes about six minutes.
The E-42B reboots after installation, which takes approximately 30 minutes.
NOTE: If the message “Check power and cable” displays on the monitor, verify that the copier/
printer interface cable is connected correctly to the copier/printer and the E-42B, and that the
copier/printer is on.
14 If a monitor, mouse, and keyboard are present:
The Log On to Windows dialog box appears on the monitor under the Administrator
account. Type
Fiery.1 in the password field and then click OK.