REPLACING PARTS 42
TO SHUT DOWN FROM THE COPIER/PRINTER TOUCH PANEL
NOTE: Notify the network administrator before you remove the E-42B from the network.
1 Press the “fierydriven®” button on the copier/printer touch panel (see page 27).
2 Make sure that the E-42B is not receiving, processing, or printing any jobs.
If Printing appears on the touch panel, the E-42B is processing. You must wait until the
system finishes and reaches Idle before restarting or shutting down.
If the system has just finished processing, wait at least five seconds after the system reaches
Idle before beginning the shutdown procedure.
3 On the copier/printer touch panel, press the Fiery tab and then press Restart Fiery.
4 At the next screen, select Shut Down and press OK:
Before accessing internal components, make sure that all cables are disconnected from the
back of the E-42B.
To Next Page
Loading...
Need help?
General
