LIST OF FIGURES 8
FIGURE 21: Removing/replacing the power supply 74
FIGURE 22: Removing/replacing the hard disk drive bracket 77
FIGURE 23: Removing/replacing the hard disk drive from/in the hard disk drive bracket 78
FIGURE 24: component sled with switch bank assembly 80
FIGURE 25: Removing/replacing the component sled from the chassis 81
FIGURE 26: Removing/replacing the switch bank assembly 82
FIGURE 27: Removing/replacing the DVD drive 84
FIGURE 28: Normal startup sequence 108
FIGURE 29: Rear central cover [A] ( x 4) 122
FIGURE 30: Controller box cover [B] ( x 4) 123
FIGURE 31: Slot cover [C] 123
FIGURE 32: Attaching the controller board. 124
FIGURE 33: Inserting the key top seal. 125
FIGURE 34: Affixing the decal on the copier/printer. 125
FIGURE 35: E-42B installed on the furniture 127
To Next Page
Loading...
Need help?
General
