REPLACING PARTS 83
4 Connect the following cables (see Figure 16 on page 56 for the location of connectors on the
motherboard):
• Power and data combination cable
• DVD data cable
• Power button cable
• Reset button cable
• Speaker cable
• Front panel USB port cables
5 Install the ferrite around the two front USB port cables near the motherboard.
Use the ferrite that you removed earlier. Place the ferrite around both cables in between the
two preinstalled tie-wraps, and snap the edges of the ferrite closed.
6 Secure the cables with the cable clamp(s) inside the chassis.
7 Reassemble the E-42B and verify its functionality (see page 85).
To Next Page
Loading...
