Page 26 / 53
8.2.10. When you confirm that the 3D model of the upper and lower jaw is complete,
continue with the buccal bite registration acquisition.
8.3 Scanning the Buccal Bite Registration
To acquire a buccal bite registration, follow these steps:
8.3.1. On the HELIOS interface, select the Buccal Bite Registration acquisition
mode
OR
Press the mode button on the scanner to select the buccal bite registration mode
8.3.2. Place the tip of the scanner into the buccal side in the patient’s mouth, then
rotate the tip to align with the teeth, close the patient’s mouth and confirm that the bite
position is correct.
8.3.3. Press the Star Scan button, slowly move the scanner tip in mesial direction with
equal coverage of upper and lower teeth. The example below shows a buccal bite
registration. You can use the toolbar on the under side to switch between the scanned
occlusion views, or delete the scanned occlusion views for rescanning.
You can scan one or two buccal bite registrations. It is recommended to scan one
on the left side and one on the right side of the patient’s mouth.
8.3.4. After scanning the buccal bite registrations, rotate the model and zoom the view
to ensure that the bite is accurate and that there are no areas where the bite is
mismatched. If necessary, you can delete the scanned occlusion and rescan.
8.4Refining and Checking the 3D Model
Refining the 3D model allows you to obtain higher accuracy data for further processing.
To refine the 3D model, follow these steps:
8.4.1. Click the button, the refining progress bar will be displayed. Depending
on your computer configuration, the refining process may take several minutes.
To Next Page
Loading...
