Page 47 / 53
13 Electromagnetic Compatibility Precautions
Medical electrical equipment requires special precautions regarding
electromagnetic compatibility (EMC). Medical equipment must be installed and put
into service according to the EMC information provided in this documentation.
Other equipment can interfere with communications with the HELIOS 600, even
if the equipment complies with CISPR emissions requirements.
Portable and mobile RF communications equipment (including
peripherals such as antenna cables and external antennas) should be used no closer
than 30 cm (12 inches) to any part of the HELIOS 600, including cables specified by
the manufacturer. Otherwise, degradation of the performance of this equipment could
result.
13.1 Guidance and Manufacturer’s Declarations
13.1.1 Guidance and Manufacturer’s Declaration - Electromagnetic Emissions
The HELIOS 600 is intended for use in the electromagnetic environment specified
below. The customer or user of the HELIOS 600 should assure that it is used in such
an environment.
13.1.2Guidance and Manufacturer’s Declaration – Electromagnetic Immunity for 13.2
13.2 Equipment and Systems
13.2.1 The HELIOS 600 is intended for use in the electromagnetic environment
specified below. The customer or the user of the HELIOS 600 should assure that it is
used in such an environment.
Electromagnetic Environment - Guidance
Electromagnetic Environment - Guidance
The HELIOS 600 uses RF energy only for its
internal function.
Therefore, its RF emissions are very low and are
not likely to cause any interference in nearby
electronic equipment.
To Next Page
Loading...
