Eighteeth Helios 600 - Page 4

Table of Contents
Page 4 / 53
8 Acquiring a 3D Model for Orthodontics .................. 24
8.1 To acquire a 3D model, follow these steps: .... 24
8.2 Scanning the Upper and Lower Jaw ............... 24
8.3 Scanning the Buccal Bite Registration ............ 26
8.4Refining and Checking the 3D Model ............... 26
8.5Completing and Saving the 3D Model .............. 27
9.Acquiring a 3D Model for Restoration .................... 29
9.1 Scanning the Upper and Lower Jaw ............... 29
9.2 Scanning the Buccal Bite Registration ............ 31
9.3 Marking the Preparation Areas ....................... 32
9.4 Refining and Checking the 3D Model .............. 32
9.5 Completing and Saving the 3D Model ............. 33
10.Acquiring a 3D Model for Implant ........................ 34
10.1 To acquire a 3D model, follow these steps: .. 34
10.2 Scanning the Upper and Lower Jaw ............. 34
10.3 Scanning the Buccal Bite Registration .......... 35
10.4Marking the Implant Areas ............................. 36
10.5 Installing and Scanning the Scan Body ......... 37
10.6 Refining and Checking the 3D Model ............ 38
10.7 Completing and Saving the 3D Model ........... 39
11Cleaning, Disinfecting, and Sterilizing .................. 40
11.1 Cleaning the Scanner ................................... 40
11.2 Disinfecting the Scanner ............................... 40
11.3 Visually Inspecting the Scanner for Damage 41
11.4 Cleaning and High-Level Disinfecting Tips .... 41
11.5 Manually cleaning HELIOS 600 Tips ............ 42
11.6 Cleaning the HELIOS 600 Tips in an Automatic Washer 42
11.7High-Level Disinfection for HELIOS 600 Tips 42
11.8 Cleaning and Sterilizing Tips ......................... 42
11.9 Manually cleaning HELIOS 600 Tips ............ 43