If the following assemblies are repaired or replaced the counter may require recalibration for proper op-
eration.
Power Supply, A101
Gate Generator, A107
Converter Control, A1 08
Microwave Converter, A203
Care should be taken when removing any assemblies to prevent damage to components or cables.
FACTORY
If the counter is being returned to EIP for
service or repair, be sure to include the following information
with the shipment.
Name and address of owner.
Model and complete serial number of counter.
A COMPLETE description of problem (Under what conditions did problem occur? What was the
signal level? What equipment was attached or connected to the counter? Did that equipment
experience failure symptons?)
Name and telephone number of someone familiar with the problem that may be contacted by
EIP for any further information, if necessary.
Shipping address to which the counter
is
to be returned. Include any special shipping instructions.
Pack the counter for shipping (Refer to Section 2).
FIELD
EIP has an assembly exchange program. All plug in assemblies, modules, and the front panel assembly may
be exchanged.
After identifying the faulty assembly, call
EIP with the assembly number and shipping information. A
replacement will be shipped within 24 hours. After the replacement assembly has been received, return
the faulty assembly to EIP for credit.
Scans by ArtekMedia © 2007
To Next Page
Loading...