Eizo DuraVision FDF4627W-IP

23
Chapter 2 Conguring from the monitor screen
Other
Attention
• It is not possible to congure the network camera when its “Protocol” is set to “ONVIF”,“AXIS”, or “DirectUri”.
2
1
1. Congure the items.
Item Detail Setting range
Pan / Tilt-ip Turn on / off the pan / tilt-ip function
*1
. On / Off
Upside-down
*2
Turn on / off the network camera upside down
function.
On / Off
Indicator Turn on / off the network camera Indicator. On / Off
*1 The pan / tilt-ip function reverses the pan / tilt direction automatically at high-speed when the network
camera reaches the movement endpoint. This function allows the user to make pan / tilt operations
without paying attention to movement endpoints.
*2 Check the network camera installation specications before using the upside down function.
Depending on the network camera type, it may not be possible to install the camera upside down even
when the camera supports the upside down function.
2. Select “Apply”.
The setting complete screen is displayed. Select “OK”.