Eizo DuraVision FDF4627W-IP

22
Chapter 2 Conguring from the monitor screen
Preset
Preset the shooting position and adjustment status of the network camera.
2
1
3
Displays images of the selected network camera.
1. Select the number (1 to 256) to set for “Preset No”.
2. Congure the items.
Item Detail Setting range
Brightness Adjust the network camera brightness. According to the camera specication
Focus Adjust the network camera focus. According to the camera specication
Zoom Adjust the network camera display
magnication.
According to the camera specication
Position Adjust the network camera shooting
position (pan / tilt).
According to the camera specication
3. Select “Register (Home)” for registering the selected number as the home position. For all other
registrations, select “Register”.
The registration completion screen is displayed. Select “OK”.
Attention
• It is not possible to congure the network camera when its “Protocol” is set to “AXIS” or “DirectUri”. Set the
preset settings on the camera side.
• Depending on the type of the network camera you are using, some functions may not be available.
• Depending on the network camera type, it may not be possible to register the brightness and focus settings.
Note
• After the setting is registered, the number displayed at “Preset No.” changes from “Not Registered” to “Home”
or “Registered”.
• To clear a setting, select the number to clear at “Preset No.” and then select “Delete”. The data set for the
number is deleted and the number status returns to the unregistered state.