Eldes EPIR3 - Page 38

38
38 EN
EPIR3 User Manual v1.3
3. After the system is successfully disarmed, LED indicator ARMED will light o and the system will reply with
conrmation by SMS text message to User 1 phone number (by default).
EPIR3
SMS
User
71
3.3.5. About STAY mode and how to activate it by EKB3W
Stay mode allows the user to arm and disarm the alarm system without leaving the secured area. If the zones
with Stay attribute enabled are violated when the system is Stay-armed, no alarm will be caused. Typically, this
feature is used when arming the system at home before going to bed.
The system can be Stay-armed under the following conditions:
• Automatic - If a Delay-type zone is NOT violated during exit delay and a zone (-s) with Stay attribute enabled
exists, the system will arm in Stay mode. When arming the system in Stay mode under this condition, one of the
available arming methods must be used that provide exit delay.
• Manual - The system will skip exit delay countdown and instantly arm in Stay mode when using EKB3W keypad
(see below).
1. Arm the system in Stay mode manually by entering the following combination using [STAY] and number keys:
1
7
4
2
8
5
0
3
9
6
Press the [STAY] key & enter user code:
STAY uuuu
Value: uuuu - 4-digit user code
Example: STAY1111