51
Replace the PCB
Re-enter user-desired parameter
settings (time per push/coin, for
example). These are erased
when factory defaults are
restored.
NO
YES
E 10 - Programming errors - (Settings)
Error description
This error occurs when the parameter set-up is inconsistent.
Note! When resetting the circuit board the user adjusted programs disappear and need
reprogramming.
The dryer stops operating.
Error analysis
1. Enter the service
program.
Set Menu 10-1 to "1"
to restore all factory
settings.
All user-desired
programming will be
overwritten.
Exit programming
mode and attempt to
operate the dryer.
Does the E10 return?
Troubleshooting
To Next Page
Loading...
