64
E 22 - LM10, polling error
Error description
This error is displayed if the dryer is connected in a LM10 system and the PC does not
communicate with the dryer (no polling) within 90 sec (time out factory setting).
The error can only be removed, if communiction is re-established.
Note! It is not possible to use the dryer, however, it can be done by means of the “free of
charge key”.
Error analysis
Start the LM10
which is connected
to the ELS Network
Go to step 2.
NO
YES
1. Has LM10
been started?
3. Has the ELS
Network been
set up correctly
reg. Baud rate,
addresses and
time out. An
address cannot
be used twice.
NO
YES
2. Has the ELS
Network been
connected
correctly.
NO
YES
Go to step 3.
Mount the ELS
Network cables
correctly
Make an error
diagnosis in the
LM10 system.
Mount the ELS
Network cables
correctly
Troubleshooting
To Next Page
Loading...
