5.2 Installation menu page
1. Select menu choice 1. Installation by pressing OK key on selected item:
2. Select Manufacturer (Mfr) or Meter (Dev). If left blank (---), all meters will be installed.
Proceed by pressing OK:
3. 1. Start, keep - Keep already installed meters and stay in installation mode for 60 min, (or chosen
time).
2. Start, clear all. – Clear all installed meters.
3. Start, cont. – Keep already installed meters and stay in installation mode (until it is manually
turned off).
Change installation choice with up/down keys, choose installation by pressing OK:
4. Now the product will listen for all wireless M-Bus slaves in range which operates in wireless M-Bus
mode C1 and T1. The following information is shown on the display:
5. The installation will by default proceed for 60 minutes, but can be stopped at any time by pressing
the ESC key.
6. The installed wireless M-Bus slaves can be read on any M-Bus slave port using primary or secondary
addressing on 2400 baud.
To Next Page
Loading...
