Elvaco CMeX50 - Introduction; Product Configuration; Capabilities; Applications

CMeX50 Users Manual English
CMeX50 Users Manual English
page | 8 (89)
2017-10-13
Document id: 1090055 Version 1.5
3 Introduction
3.1 Product configuration
Use the table below to find out the capabilities of your product.
Product name
Comments
CMeX50
Wireless M-Bus Receiver handling 800 Wireless M-Bus slaves
Table 1 Product configuration
3.2 Capabilities
The CMeX50 is a wireless M-Bus Receiver handling up to 800 wireless M-Bus slaves and up to 32 wired M-
Bus slaves. The product can operate in all commonly used wireless M-Bus modes; T1, C1, and S1.
The CMeX50 will virtualize the connected wireless M-Bus slaves and the slaves will be readable using
standard M-Bus commands. The CMeX50 can be read using RS232, USB and standard M-Bus 2-wire. This
makes the product usable in any standard M-Bus system, without having any knowledge about wireless
M-Bus.
The CMeX50 can be used together with Elvaco CMe/CMeX Series products, which enables GSM/GPRS
communication, TCP/IP communication, M-Bus Master extension modules and much more.
3.3 Applications
The CMeX50 should be used in the following scenarios:
• Radio networks in villa-areas
• Radio networks in tenant owners associations
• Reading any type of wired M-Bus slave
• Reading any type of wireless M-Bus slave supporting T1, C1, or S1