CMeX50 Users Manual English
CMeX50 Users Manual English
Document id: 1090055 Version 1.5
The installation time is the time the product will stay in installation mode when starting an installation.
Change the installation time of the product by using Up/Down keys.
Accept the changes by pressing OK or cancel by pressing the ESC key.
5.5.5 Edit installation mode
Select menu choice 5. Install mode using Up/Down keys and press OK key.
The installation mode is used to configure which wireless M-Bus telegrams are accepted for installing new
wireless M-Bus slaves in installation mode. See Table 5 for available modes.
Change the installation mode of the product by using Up/Down keys.
Accept the changes by pressing OK or cancel by pressing the ESC key.
Only telegrams of type SND_IR will be able to add new meters during
installation. See 6.1.4.
All valid telegrams will be able to add new meters during installation
Table 5 Installation modes
5.5.6 Edit data age limit
Select menu choice 6. Data age limit using Up/Down keys and press OK key.
The data age limit is the maximum time in minutes a wireless M-Bus telegram is valid for readout on the
wired M-Bus interface. If a telegram is older than the data age limit, the corresponding virtualized wired
M-Bus slave will stop responding to any requests.
Change the installation time of the product by using Up/Down keys.
Accept the changes by pressing OK or cancel by pressing the ESC key.
5.5.7 Handling of telegram with CI = 0x79 och 0x69 (Compact data / format frame)
Select menu choice 7. CI=0x79 using Up/Down keys and press OK key.
Change the installation time for the product using Up/Down keys.
Accept the changes by pressing OK or cancel by pressing the ESC key.
Save the whole received telegram in original condition. The telegram will be
placed in a ”data container” when retrieved via wired M-Bus.
Table 6 Choice of container, not container mode
To Next Page
Loading...
