Safety Instructions
This warning sign is visible on the tester. Meaning: This equipment should only be operated
by trained personnel after carefully reading the user manual.
The system belongs to safety class 1.
The system fulfils the requirements of the safety standards IEC 61010 for laboratory measurement equip-
ment "Safety requirements for electrical measuring, control and laboratory equipment".
Consider always the following safety points
• Dangerous mains voltage or high voltages are present inside the test equipment and ALL devices
attached to it.
• The Protective Earth must be connected to Earth on the test equipment.
• Before removing any covers from the test equipment, remove all external connection cables.
• Before changing the mains fuse, remove all external connection cables.
• Fuses should only be replaced with the same type and value.
• People with heart pacemakers must not be in the vicinity of the test equipment when it is in
operation.
• Do not switch on or operate the test equipment if an explosion hazard exists.
• The test equipment should be operated in a dry room. If condensation is visible, the affected
unit(s) should be dried before operating.
• Never touch the Equipment Under Test (EUT), when the test system is operating.
• Establish a safety barrier around the EUT and if required connect it to the safety circuit in the
auxiliary connector on the rear panel. The cables under high voltage must not be touched during
testing.
• The EUT should be covered and/or well marked during the tests.
• If protective parts are tested, which are likely to explode during tests, they must be covered with
a protective cabinet.
• If the test equipment or any of the system components are damaged or it is possible that damage
has occurred, for example during transportation, do not apply any voltage.
• This user manual is an integral part of the test system. EMC PARTNER and its sales partners
refuse to accept any responsibility for consequential or direct damage to persons and/or goods due
to non-observance of instructions contained herein or due to incorrect use of the test equipment.
Page 3/55
To Next Page
Loading...