EMC2 VNX5500 - Power Up the VNX5500 DAE

54 EMC VNX5500 File Installation Guide
Power up the DAE
Ensure that the cabinet circuit breakers are still on and the PDUs are powered on. The DAE power
cables should be connected directly to the PDUs as shown in Figure 44. After they are connected,
the DAEs will begin to power up.
Note: Ensure cabinet receptacle power where the DAEs will be connected to is on.
1. Connect or verify that the DAE 1 power cable is connected to PDU A.
2. Connect or verify that the DAE 1 power cable is connected to PDU B.
3. Connect or verify that the DAE 2 power cable is connected to PDU A.
4. Connect or verify that the DAE 2 power cable is connected to PDU B.
A
B
C
D