VNX File configuration worksheet
67
Planning Worksheets
Table 9 Blade public LAN settings
Field Value Comments
DNS domain Auto-discovered (required). These settings
apply to all primary blades.
If you want to configure the IPv6 addresses
for the blades (DNS or NTP), first use the
VNX Installation Assistant for File/Unified
for the initial installation and then refer to
the Configuring and Managing Networking
on VNX technical module and
EMC VNX
Command Line Interface Reference for File
to complete the IPv6 additions.
Note: The values auto-discovered for the
secondary DNS server are optional.
Primary DNS server
Table 10 Service Provider/Customer Notification
Field Value Comments
Email Server Optional
Email will not work without a DNS server.
Site Information:
Recipient Email Addresses Optional
Site ID Optional (third-party name)
Dial-in-Modem # Optional
This is the local number that is used by the
service provider to dial into your system.
Table 11 Licenses
Field Value Comments
— CIFS (Windows) Required
Check the boxes of the licenses you have
purchased.
— NFS (UNIX or Linux)
— Replicator V2
— File Level Retention
— Snapsure
To Next Page
Loading...
