100-412-182 REV. 06 7
1.2.2 Intended Use of the System
The 2000X-series Power Supply and 2000X Micro Actuator are components of an
ultrasonic welding system. These are designed for a wide variety of welding or processing
applications.
1.2.3 Safety Measures and Guards
The 2000X Micro Actuator, along with its 2000X distance Power Supply, contains software-
controlled electronic safety devices intended to prevent the machine from operating in a
fashion harmful to the user. Start Switch and Emergency Stop controls are designed to
prevent undesirable startup.
1.2.4 Emissions
When being processed, certain plastic material can emit toxic fumes, gases or other
emissions that can be hazardous to the operator’s health. Where such materials are
processed, proper ventilation of the workstation is required. Check your materials
suppliers for recommended protection when processing their materials.
1.2.5 Setting up the Workplace
Measures for setting up a workplace for safe operation of the ultrasonic welder are
outlined in Chapter 1: Safety and Support and in the 2000-series Installation guide.
1.2.6 Regulatory Compliance
This product meets electrical safety requirements and EMC (Electromagnetic Compliance)
requirements for North America and the European Union.
CAUTION General Warning
Processing of many materials, such as PVC, can be hazardous to an
operator’s health and could cause corrosion/damage to the
equipment. Use proper ventilation and take protective measures.
To Next Page
Loading...
Need help?
General
