100-412-182 REV. 06 63
5.7.2 Connecting Tip to Horn
1. Clean the mating surfaces of the horn and tip. Remove foreign matter from the threaded stud
and hole
2. Hand assemble the tip to the horn. Assemble dry. Do not use any silicone grease
3. Use the spanner wrench and an open-end wrench (refer to
Figure 5.13) and tighten to the tip
torque specifications in
Table 5.10 Tip to Horn Torque Specifications
Figure 5.13 Connecting Tip to Horn
NOTICE
Add a drop of Loctite
®
290 threadlocker to the stud. Torque and let
cure for 30 minutes before use.
Table 5.10 Tip to Horn Torque Specifications
Tip Thread Torque
1/4 - 28 110 in-lbs, 12.42 N·m
3/8 - 24 180 in-lbs, 20.33 N·m