Emerson Daniel Danalyzer 1000 - Equipment Description; Sampling System; Analyzer; Controller

SEP 2005 MODEL 1000
TABLE OF CONTENTS
iv
2.2 ANALYZER ...................................................... 2-5
2.2.1 Physical Description .................................................2-5
2.2.2 Chromatograph Valves ...............................................2-7
2.2.2.1 Primary Plate .................................................... 2-8
2.2.2.2 Actuating Subassemblies ...........................................2-8
2.2.2.3 Operation ...... ............ ............ ......... ............ .... 2-8
2.2.3 Detector Subsystem ..................................................2-8
2.2.4 Analyzer Preamplifier Unit ............................................2-8
2.2.5 Analyzer Specifications ..............................................2-9
2.2.6 Utility Gas Requirements ............................................2- 10
2.3 CONTROLLER .................................................. 2-10
2.3.1 Controller Hardware Configurations . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-11
2.3.1.1 Analog Inputs and Outputs .........................................2-12
2.3.1.2 Digital Inputs and Outputs .........................................2-13
2.3.1.3 Communications................................................. 2-13
2.3.1.4 Driver Outputs ..................................................2- 14
2.3.1.5 General Controller Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-14
2.3.1.6 Electrical / Mechanical Safety and Integrity -
Certifications and Classifications: ...................................2-15
2.3.1.7 GC Controller Circuit Board List ....................................2- 16
2.3.2 Optional Keyboard and Display .......................................2-21
2.3.2.1 Key Pad ....................................................... 2-21
2.3.2.2 Display ........................................................ 2-21
2.3.3 Alarm Specifications ................................................2- 21
2.3.3.1 Status Indicators .................................................2-22
3.0 INSTALLATION AND SETUP....................................... 3-1
3.1 PRECAUTIONS AND WARNINGS ...................................3-4
3.1.1 Hazardous Environments .............................................3-4
3.1.2 Power Source Wiring ................................................3-6
3.1.3 Signal Wiring ......................................................3-7
3.1.4 Electrical and Signal Ground ..........................................3-9
3.1.5 Electrical Conduit ..................................................3- 11
3.1.6 Sample Systems Requirements ........................................3-13